Three Point Rectangle
Command
Three Point Rectangle
Shortcut
-
Button
Toolbar
Create a rectangle by specifying three points. Length can be set using mouse actions or with a numerical value.
- Click the button on the toolbar.
- Click at the start point of one side of the rectangle.
- Tab Specify length a numerical value.
- K Knife: Use Knife Mode.
- X/ Y/Z X/Y/Z-axis: Constrain to the X, Y, or Z-axis.
- Click at the endpoint of the same side of the rectangle.
- Click at the third point of the rectangle.
- Confirm with OK in the Command Dialog or right-click.
- A rectangle is created.