Control Point Curve
Command
Control Point Curve
Shortcut
-
Button
Toolbar
Create a Curve by placing Control Points.
- Click the button on the toolbar.
- Click at the start point of the control point curve.
- Click the points through which the Control Points of the Curve will pass. Repeat the clicks to create a control point curve.
- K Knife: Use Knife Mode.
- Tab Control / Through-point: Switches to Spline curve.
- Ctrl + Z Undo: Cancels the last click.
- X/ Y/Z X/Y/Z-axis: Constrain to the X, Y, or Z-axis.
- Confirm with OK in the Command Dialog or right-click.
- A Curve is created.
💡
Differences Between Two Curves
- Spline Curve: Click the points that the Curve will pass through to create the Curve.
- Control Point Curve: Click the Control Points of the Curve to create the Curve.