Bridge Edge

Bridge Edge

Command
Bridge Edge
Shortcut
-
Button
-

Bridges two Edges that can be G0/G1/G2/G3 continuous. Specify which end of the Edges to bridge. Tension is adjustable.

  1. Select two Edges you want to bridge.
  2. Use the Bridge command in the Command Palette
  3. Set the options in the Command Dialog and Keyboard Shortcuts.
    • Side:
      • Side 1: Specify which side of the endpoint of the initially selected Edge to bridge to.
      • Side 2: Specify which side of the endpoint of the subsequently selected Edge to bridge to.
      • T:
        • Value 1/2: The relative position on the segment of the starting point/ending point.
      • Direction:
        • Direction 1/2: Reverse the direction of the starting point/ending point.
      • Tension 1:
        • Value 1/2: The tension value affected 1st Control-Vertex(CV) to 3rd CV of the starting point/ending point.
      • Tension 2:
        • Value 1/2: The tension value affected 2nd CV and 3rd CV of the starting point/ending point.
      • Tension 3:
        • Value 1/2: The tension value affected 3rd CV of the starting point/ending point.
      • Start curvature:
      • End curvature:
    • Trim: When turned on, any Curve that extends beyond the bridge will be trimmed.
  4. Confirm with OK in the Command Dialog or right-click.

See also