Rebuild Face

Command

Rebuild

Shortcut

-

Button

Right of Command Bar

Rebuild the surface of a face.

Basic Usage

1. Select a face or faces you want to rebuild.
2. Use the Rebuild command in the Command Palette or click on the Rebuild Button on the Right of Command Bar.
3. Set the options in the Command Dialog.
   • Command Dialog
   • Method:
     • Explicit control:
       • Degree: Specify the U and V degree value.
       • Spans: Specify the U and V spans value.
       • Extend: Specify the U and V extend value.
       • Shrink: Shrink projecting rows and columns of CVs to fit more closely to the boundary edges of the trimmed surface.
     • Tolerance:
       • Tolerance: Specify the tolerance of surface CV count. Lower value results in large number of surface CVs and higher value results in small number of CVs. This determines the surface output quality.
       • Extend: Specify the U and V extend value.
       • Shrink: Shrink projecting rows and columns of CVs to fit more closely to the boundary edges of the trimmed surface.
4. Confirm with OK in the Command Dialog or right-click.

See also

• Rebuild
• Raise Surface Degree